To configure the DHCP setting for the LAN ports of a pronto router, begin by navigating to Configuration>Network, here make sure you select the Network you are configuring from the dropdown.


  • Create a new SSID by selecting the +Add SSID button.

  • Begin by configuring the EDIT SSID section

    • Select the APs or ROuters the SSID applies to.

    • Name the SSID

    • Select SSID policies - I.e Status, hidden, isolate

    • Select Radio Band - 2.4 GHz, 5 GHz, Both

    • SSID Max Associations

    • Policies

    • Assocaitions

    • Encryption and Authentication Key 

    • SSID WDS

    • Router vs Bridge Mode

      • Selecting Router vs Bridge Mode provides different options for the user in this section. 


  • Bridge Mode - This mode enables a VLAN Settings subsection, where a user can select a VLAN created in the network section



  • Router Mode - This mode enables a number of Features including 

    • IP Configuration 

  • Configure a gateway IP address under IP Address.

  • Configure the DHCP pool netmask under Netmask.

  • Configure DNS Mode



  • DHCP Settings 

  • Under DHCP Server, switch to Enable. 

  • Set the DHCP Lease Time (in seconds).

  • Set the DHCP range first and last Host addresses.

  • If needed, you can map IP address to specific WIFI devices here


  • Captive Portal Settings

    • If you need to setup Captive portal on the WIFI, select enable in the Captive Portal section and fill out the necessary details 




  • Once the WIFI profiles is configured, Click Create SSID